02-01-2018
02:37 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
02-01-2018
02:37 PM
Finally getting around to fully testing this post.
The coolant works good! Thanks....however I am running into one other issue. The Z height is running about 2" above the actual part when I run the program.
I am not sure it this is a post issue or if I am doing something wrong in the Fusion setup. I have touched off my tool to the top of the part and set the offset correctly.
Any suggestions?
Thanks
Kevin
Fusion