01-31-2018
08:33 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
01-31-2018
08:33 PM
Is there any way you could add tabs on a 3d toolpath where it is stock
aware. The only software I have found to do this is mastercam. It's just
really expensive. It seems like such a simple thing to do. I have
workarounds but They all add a lot of time. Time is money you know.
Thanks for your reply
aware. The only software I have found to do this is mastercam. It's just
really expensive. It seems like such a simple thing to do. I have
workarounds but They all add a lot of time. Time is money you know.
Thanks for your reply
Fusion