01-06-2018
05:48 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
01-06-2018
05:48 PM
This is pretty simple and programming one hole and adding those toolpaths to a Linear Pattern could speed things up dramatically. If you still want to use 3D Adaptive, you can pretty easily use a sketch to contain the toolpath entirely (the screencast below is just one way to alter a toolpath using sketch containment, try just sketching a box that you want the toolpath to limit itself inside of):
Neal Stein
New to Fusion 360 CAM? Click here for an introduction to 2D Milling, here for 2D Turning.
Find me on:
Instagram and YouTube
New to Fusion 360 CAM? Click here for an introduction to 2D Milling, here for 2D Turning.
Find me on:
Instagram and YouTube
Fusion