01-06-2018
05:39 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
01-06-2018
05:39 PM
The holes will have to be patched, which can be done in the Patch environment, and then you can add the patches to the Parallel toolpath (but not the Setup) on the Geometry tab; they will be ignored by any other 3D toolpaths.
Neal Stein
New to Fusion 360 CAM? Click here for an introduction to 2D Milling, here for 2D Turning.
Find me on:
Instagram and YouTube
New to Fusion 360 CAM? Click here for an introduction to 2D Milling, here for 2D Turning.
Find me on:
Instagram and YouTube
Fusion