Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
utekcnc
in reply to: utekcnc

Good Morning,

 

I figured out how to adjust my boring bar return point.   I do that in the Radii tab when editing the operation or process.   I still am fighting the following:

 

1.  boring bar tool size--not sure I'm defining it correctly.   I'm using a 3/8 bar with a TCMT insert.

2.  How to cut the back chamfer with my grooving part off tool.

3.  How and where to define my 5 degree relief angle on the grooving partoff insert.

 

Thanks again.