12-20-2017
02:44 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
12-20-2017
02:44 AM
Hi -
Can you share a representative model?
Offhand, I think the typical way to do this would be to use a single 2d profile strategy for the whole sheet, and go ahead and do the regeneration if you change what's on it. The toolpaths for the individual components may not, in all cases, be completely independent, so at least in some scenarios, having them all in a single operation may make the most sense, so that the toolpath generator can consider them all together, rather than having separate operations for each.
Jeff
Fusion