Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
alan
1228 Views, 4 Replies

Tool Offsets

Hello,

 

I am milling a pocket that is a lot like a slot.  In the past I have been able to adjust the tool offset diameter at the machine to increase the width of the pocket.  This particular post when I change the diameter offset on the machine nothing changes.  I even made the error of not pre setting the offset to the diameter of the end mill being used.  Normally that would have resulted in an oversize or undersize pocket.

 

What am I missing?

 

Thanks