10-20-2017
01:51 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
10-20-2017
01:51 AM
whenever i clear an area with 2d adaptive clearing, it always leaves some stock in the middle. The fusion simulation always shows the cutter clearing it out easily, but when it machines it it leaves it on. Im using the hurco 3d post processor. Anybody know where I should start looking at first? Pic below, and I know its only supposed to be a roughing cycle, but it creates extra work to clear. thanks for any help.
Solved! Go to Solution.
Fusion