Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
Steinwerks
in reply to: Anonymous

The Model selection in the toolpath is really for adding geometry not included in your Setup definition, such as patched holes or extended surfaces. One thing you can try here is to select that fillet using the Avoid/Touch Surfaces selection tool and check the Touch Surfaces box at the bottom.

 

I highly recommend this webinar recording about how to contain and utilize 3D toolpaths by Marti Deans. The 3D stuff begins at around 44 minutes:

 

Neal Stein

New to Fusion 360 CAM? Click here for an introduction to 2D Milling, here for 2D Turning.

Find me on:
Instagram and YouTube