Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
HughesTooling
in reply to: Anonymous

On the page you set mach to diameter mode there should be an option to reverse arcs, try swapping that as well. After setting to diameter mode double check your X is moving the correct amount, you might need to adjust your steps per inch as well.

 

Mark

Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

EESignature