01-24-2017
06:14 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
01-24-2017
06:14 AM
Hi thanks both for the precious input.
Setting Mach to Diameters fixed the width problem, the circles are staying, they are in the GCode after all.
I am trying to update my post processor files on the A360 Drive, it's trying to open (this will take a few minutes) for the past 20 minutes, once I have access I'll give this a try.
I suspect that (have a look at the project) the boring job I am trying to make is not quite right, it's facing and it's a spline, the software might just not like it and do those funny things you see in the picture.
Fusion