Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
Anonymous
in reply to: Steinwerks

Yes we had that known value inside Surfcam of -.1286

It happened behind the scenes in the software so it was easily forgotten about.

And the other thing was we probed the top of the table for our G54 Z0 We didn't use the actual pivot point of rotation

So this required the shift.

 

So this still brings me one question maybe you can answer.

Going with this way of 5 axis you all have me going. What do you do in this scenario?

 

Second op 5 axis part.

In a 4" Vise.

 

WCS is

X0 = left side of finished square part (against mill stop)

Y0 = Hard Jaw

Z0 = Top of Parallel's

 

Now the vise is always going to be placed in various spots on the table at every set up.

And so will the vise stop.

 

IF this was a production job do you need to Physically move the model to how the set up tech did at the time of  set/up every time you run the job?

Or is there another way?