01-13-2017
08:22 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
01-13-2017
08:22 PM
Ok great, thank you.
ive made the change below and saved them in configuration but after re posting the code there still seems to be many lines missing feed rates, although one positive is that line 43 which was originally an issue seems to now have a feed rate.
getting closer, tomorrow I will get to the shop and try a air run just to be sure but I speculate much of the same errors will occur
The worse part is, the forum will not allow me to post/attach my processor or the code - I'm getting errors saying unsupported file type.
Fusion