06-14-2015
08:37 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
06-14-2015
08:37 PM
Scott,
to copy an op to the same or different setup, right click the op and hit copy; then right click the SETUP where you want the op and hit paste. Then just edit the geometry selection for the new op. Hope that is what you were looking for.
That warning about heights pops up alot when I'm working in CAM, usually with no real effect on how well the tool path performs. I think the usual culprit is the safe distance setting near the top of the linking tab. Otherwise something is most likely amiss on the Heights tab.
Fred
Fusion