11-24-2016
09:07 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
11-24-2016
09:07 AM
In addition to @LibertyMachine's post, you likely have From Selected Contour as your Bottom Height choice. If you choose something such as From Model Bottom it should override the separate heights and create a continuous toolpath.
Also good to note I think is that Alt+selection is sort of an override, and personally I very much prefer to utilize one single chain if at all possible (sometimes model issues make this impossible, but not in this case).
Neal Stein
New to Fusion 360 CAM? Click here for an introduction to 2D Milling, here for 2D Turning.
Find me on:
Instagram and YouTube
New to Fusion 360 CAM? Click here for an introduction to 2D Milling, here for 2D Turning.
Find me on:
Instagram and YouTube
Fusion