Anonymous
830 Views, 4 Replies
10-30-2016
08:06 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
10-30-2016
08:06 AM
All advise welcome. I have an X-Carve and installed the Easel post processor, now the only post processor that shows up in the drop down list is Easel. Want to bring back what came with Fusion 360. Any help with this greatly appreciated.
Solved! Go to Solution.
10-30-2016
08:26 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
10-30-2016
08:26 AM
In the screenshot you'll see the Setup button on the righthand side. Click this and scroll down to "Use Generic Posts":
Neal Stein
New to Fusion 360 CAM? Click here for an introduction to 2D Milling, here for 2D Turning.
Find me on:
Instagram and YouTube
New to Fusion 360 CAM? Click here for an introduction to 2D Milling, here for 2D Turning.
Find me on:
Instagram and YouTube
10-30-2016
08:51 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
10-30-2016
08:51 AM
Hey thanks for the quick response. I did what you said and i'm back where i want to be. If you could you be so kind as to recommend a generic processor for use with an X-carve CNC?
Thank you,
Andrew
10-30-2016
09:07 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
10-30-2016
09:07 AM
After a quick glance over their G-code spec ( https://inventables.desk.com/customer/portal/articles/2258567?b_id=9562&t=0 ) I would probably start with the RS274D or Generic Fanuc posts, but those are comfortable for me and I have no experience with the X-Carve machines at all. It will likely involve troubleshooting and altering the posts. Hopefully someone with knowledge of those machines can chime in, or you can ask on the Inventables forums: https://discuss.inventables.com/
Neal Stein
New to Fusion 360 CAM? Click here for an introduction to 2D Milling, here for 2D Turning.
Find me on:
Instagram and YouTube
New to Fusion 360 CAM? Click here for an introduction to 2D Milling, here for 2D Turning.
Find me on:
Instagram and YouTube
10-30-2016
09:22 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
10-30-2016
09:22 AM
Hey thanks Steinwerks,
Will try those and take your advice and consult Inventables community.
Andrew
Fusion