Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

@rumpelstielz I downloaded the file from the other thread and I have one idea. If you enable smoothing you get far fewer lines of code and it will speed up the sim a bit. I've attached a file, take a look at the tolerance and smoothing tolerance. For finishing ops I set it to 0.0005 and 0.00075 and the contouring op dropped from 2.9mb to 244kb, not sure why you get all the collision warnings in that op, don't have time to look at the moment. Anyway try this file and see if it's any better. I have added smoothing to the adaptive cuts as well.

 

 

Mark

Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

EESignature