10-23-2024
08:56 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
10-23-2024
08:56 PM
Typically your ramp feed rate will be much slower than your milling feed so you wouldn't need to apply a reduced feedrate for the corners anyway.
your tool is a decent amount smaller than the slot so it shouldn't be a problem.
I've only ever used Feedrate optimization a handful of times when using very long tools, in most other cases I find its not necessary.
You may have more of a need with a less rigid machine though
Fusion