08-19-2024
11:48 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
08-19-2024
11:48 AM
While you did have a machine config file, it was not setup similar to the one that was in the file I shared. There were settings in the -A- axis config that were not correct, they needed to look like this:
I've attached your file, you will need to copy these changes over to your own machine config file. I've also attached the resulting NC code for you to verify that my results were indeed what you were looking for.
This was using the fanuc_noG68 post I shared earlier.

Seth Madore
Customer Advocacy Manager - Manufacturing
Fusion