08-19-2024
09:57 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
08-19-2024
09:57 AM
So, I took my file and posted it out with the fanuc A-axis inverse time and A-axis and I also think there is something wrong with the wrap toolpath. In simulation in fusion everything looks normal, but after you post the code and put the code on the machine, the machine does fine till after it hits the G43 and then the machine trips out and instead of following the toolpath, the A axis starts spinning like its in a turning cycle. Never seen this before.
Fusion