07-02-2024
05:53 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
07-02-2024
05:53 PM
Thanks very much, tool centerpoint does help get a toolpath generated using the 45 degree orientation in the "Turning Groove" operation. However because the orientation is set in the operation, I can't use the same 45 degree orientation in any normal roughing operations. Doesn't really matter in this case that the tool is shown at 0 deg in other operations but might matter for more complex parts/machines.
Fusion