05-10-2024
01:21 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
05-10-2024
01:21 PM
Hi
The issue is you cannot currently use Cyclic geometry with Wrap (a contour that starts and finishes in the same place )
The reason you get a toolpath at all is because you have unticked "Unwrap Geometry"
This obviously results in an incorrect toolpath.
The best option here is to use Advanced swarf set to 4 axis mode, but you will need the Manufacturing extension
see attached
Fusion