Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
risa_vedoya
279 Views, 4 Replies

Post Processing for Engraving Preview Not Available

image_2024-03-19_212352479.png

I'm currently working on a project in which I have to engrave dog tags and exporting the NC file from Fusion360 has posed a quite a challenge. I was hoping someone would be able to help out.

 

In Fusion, I would specify my setup, tool, speeds, and would properly run a simulation of the engraving process. Once I complete that and go to the 'Post Process' section and create a NC file and go to view the G-Code on any software (tried NC Viewer, Visual Studio Code, and CAMotics), I get this same message as seen in the image, every time. I tried going to the link provided but it says it doesn't exist.

 

If anyone has any advice for me, please let me know. Anything would be appreciated! Thank you.