Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
AlanMueller
160 Views, 2 Replies

Turning - finishing toolpath doesn't turn over flats in design

When creating a finishing tool path, Fusion is stopping the turning at the end of the conical taper on my part, rather than continuing straight to the back of the part. Any ideas on how to correct this issue?

AlanMueller_0-1707772443220.png

 

End of tool path has a radius, which appears to begin going along the straight section of the part, but ends there. When "Make sharp corners" is on, the radius disappears, as I would expect.

AlanMueller_1-1707772489033.png

 

 

Labels (2)