Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
rengfx
in reply to: weber_dominic

I've had good success using a ball endmill, and either leaving it in 3 axis mode with Tool Orientation, or full 5 axis where I select the edges like you have and use set Axis Limits either to the Tool Orientation or the Setup Z axis

 

deburraxislimits.png

 

I actually haven't used even a chamfer mill with it, I notice on your toolpath its locked to a fixed point on the tool because its a chamfer mill, you have more flexibility with a ball endmill or lollipop mill