11-29-2023
01:57 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
11-29-2023
01:57 PM
Hope this is helpful to others:
No matter what I did I just could not get the parallel toolpath to stop giving Rapid collision errors. I was tempted to run the file anyway, and hope ofr the best.
However, thanks to some suggestions by others, I got it working by switching to a Scallop toolpath and setting the lead-ins to 1".
I'll start the milling in the morning and hopefully all will be well!
Fusion