Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
JJackrabbit
177 Views, 2 Replies

Stock to leave 3D pocket

Hi

 

Is it possible to do the following?

I use 3d pocket clearing with a high feed cutter (full WOC and small DOC).

I would like to leave some extra stock after each Z pass? So the wall will have a draft? This results in a smoother toolpath and machining.

Currently I make extra toolpaths and increase stock to leave for each specific depth. But this will cost a lot of time.