Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
bh220940
in reply to: bh220940

@a.laasW8M6T yes, why isnt that shown in the simulation? I think I won't work properly because is doesn't show the tool moving right and touching the end of the hole aka removing the material, only up and down, a because the tool is D18 and hole D35, how will the tool touch material if it won't be in contact with it? 

@Marco.Takx yes thank you, I tried that too, but the result is the same (everthing written above). But yes, I understand stepping away of the wall.