Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
Marco.Takx
in reply to: piotrVMP6A

@piotrVMP6A ,

In worst-case scenarios, you can put in the CAD model of the tool and place it at the geometry that causes you the critical situation.

And then measure the angle and use that within the operation.

 

But I understand your question very well and also I can't wait until it's implemented.

 

If my post answers your question Please use Accept as Solution & Kudos This helps everyone find answers more quickly!

Met vriendelijke groet | Kind regards | Mit freundlichem Gruß

Marco Takx
CAM Programmer & CAM Consultant