04-09-2023
03:45 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
04-09-2023
03:45 PM
i would appreciate someone please help me update my Fanuc Mill post. it was tailored for my machine a couple of years ago and i would like to update it, add inspection and add machine simulation.
i have failed miserably trying to figure it out on my own. the post that i have been using was a generic Fanuc mill post that was modified for me to allow 5 axis simultaneous without TCP.
it works great but i have since add a renishaw probe and would like to try the inspection post.
i also would like to take advantage of machine simulation.
if possible, i would like to only number the blocks that have tool changes as my control can only handle up to 99,999 numbered blocks. turning number off is getting me by so it is not a requirement.
here is the post that i have been using with the above modifications.
Fusion