Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
WillL84
in reply to: seth.madore

Possibly but almost everything else works perfectly. The only thing that doesn't other than this is that it doesn't show tool diameters on the control screen. I've set up everything in Fusion itself to work better with this 2-axis machine like removing all vertical lead-ins. This is the only TRAK post I've found that this machine will even accept. It pulls it right in as .mx2 format.

 

If I load it at gcode it doesn't do any conversions on the control side but then there's no Z breaks, it just runs the whole code at once with no pauses for tool changes, etc.

Windows 11 Pro 64-bit
Inventor 2024 Pro (PDMC)
TITAN Computers C161
i7-11700K/32GB RAM/Quadro RTX A4000