Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
Anonymous
270 Views, 3 Replies

CAM Simulation broken?! Not showing 'In Control'

Hi!

 

In the toolpath preview it shows that the last cut is done with compensation on, but when simulating it's showing like it's not compensated! Also the diameter of this tool is set as compensation point but in the preview it's below the programmed path.

 

Anyone an idea?

------

I think it's just showing the center of the tool after an another look

 

 

CoertHFT_0-1672932893943.png

CoertHFT_1-1672932922104.png