Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

If you post using the file in this thread using dump.cps you get this. The start radius and end radius are quite close so for most a G2\G3 is fine but sometimes an arc doesn't fit and you'd lose some accracy with an arc. You're probably not going the notice in a roughing cut with stock allowances but you might have a problem occasionally with some leads on finish cuts.

Clipboard01.png

 

Mark

Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

EESignature