Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
dwilliamsFM6K4
in reply to: jorsborn

Sweet! Make sure that probe tip is rotating less than .0002" TIR. I run a 6"+ probe tip so that's always fun for me

 

Yeah do the full probe calibration again + the vector probing routine HAAS has here https://www.youtube.com/watch?v=2PKUUndD8tA + https://www.haascnc.com/content/dam/haascnc/videos/bonus-content/use-vector-probing-to-probe-a-half-...

 

You'll want the probe as accurate as possible prior to any alignments