Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
jorsborn
477 Views, 9 Replies

Part Alignment on a Haas - Post Error

I am trying out part alignment for the first time. I have a large weldment that I need to drill and tap holes into. Post weld it is a little wonky so I thought this would be perfect for aligning those holes on center. However, when I attempt to post for alignment I get an error. A few relevant screen shots below. Any suggestions? I downloaded the latest post processor for the NGC but that did not help.