Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
engineguy
in reply to: jscott6SWZG

@jscott6SWZG 

 

The reason I did the Contour first was to avoid the tool hitting solid stock every time it went out the pocket but it is entirely up to you how you do it. If the Contour has already been cut then the Pocket is just moving into clear air :slightly_smiling_face:

See image below for the Stock Contour selection, just open up your Sketches and select the outer edge of the "Top" sketch, I just used what was already there, I didn`t create anything new :slightly_smiling_face:

Upper post trab binding-2.jpg