08-21-2022
02:21 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
08-21-2022
02:21 AM
Thank you so much for your support and such an elegant design solution! I have tried retracting after positioning at the end of the cycle, without any time delay, but the machine does not wait for positioning to complete and the two operations happen at the same time. This is fraught with collision - tool breakage, damaged part. There may be some machine parameter settings that affect these procedures. (HERMLE UWF 900 E) - I will try to find out from the manufacturers about this. But anyway, your solutions helped me a lot.
Fusion