06-02-2016
10:14 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
06-02-2016
10:14 AM
Yes probably, I've allready modified a post for someone using that control.
A search for CAMaster_wincnc_m3xa.cps might find the thread.
Mark
Attached is the post I modifed for someone else, don't know if there are any other differences to the one you're using so be careful.
Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Fusion