Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
engineguy
in reply to: jimMA3D3

@jimMA3D3 

 

That would likely be because the tool cutting sideways at full depth and full width in a single move which Grooving tools don`t like to do :disappointed_face:

Not likely that a 1mm tool would survive that move but you never know, what material?  :slightly_smiling_face:

 

However changing a few settings under the "Passes" tab as shown in the image below would make that Operation a lot easier on the Grooving tool, just a suggestion, it may look like an odd toolpath but should do a nice clean groove safely :slightly_smiling_face: :slightly_smiling_face: :slightly_smiling_face:

Hope this helps a little, that is the area to "play around in" for this stuff, modified file attached :slightly_smiling_face:

Bagger belt pulley.jpg