Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
Anonymous
in reply to: david

Here is what I have observed with my cnc machine

1. machine ramps down in slightly smaller diameter than desired hole.

2. machine expands outward to finish edges of the hole, cutting full depth of the hole.

My machine broke an end mill because it tried to finish the hold at full depth (step 2). Is there any way to avoid this where the entire hole is ramped with a helical fashion? Autodesk insists on finishing the hole at full depth which the endmill cant take.