Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
engineguy
in reply to: bernard5BABD

@bernard5BABD 

 

The "Q" command is in the line of code for G73 (Chip Breaking) and G83 (Deep drilling with pecking) and is standard ISO canned cycle output for Drilling cycle with "Pecking" requirement.

The G81 drilling cycle is a straight feedin/rapid out so does not have/need the "Q" command in the cycle.

 

The Fanuc Post Processor should work, it is after all the "Grandfather" of all code and a lot of machine controls use a version of Fanuc, often "Branded" as their own.

 

Do you have a Manual with G and M code lists for the control or some sample code in the Machine Control that will show you what the control accepts ??