03-08-2022
01:27 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
03-08-2022
01:27 PM
This does show some of Fusion's shortcomings with lathe work. Especially tool creation.
@CuttingEdgeManufacturing I should have shared a file earlier too I had a look quickly just before I was leaving work. I've attached the file with a working toolpath. I haven't looked at it too closely. I changed the holder shank width and I had to mess around with the radii. File is attached.
Fusion