05-08-2016
04:52 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
05-08-2016
04:52 PM
Not sure without seeing the part file, but I suspect one thing first and foremost: your stock definition.
How much deeper is your pocket than the model? The code should output to the geometry if you selected the contour (or face) at the bottom, but if your stock is defined as .04" oversize (the default) then if you touch off the top of stock that is meant to be Z0, you'll get deeper features by virtue of the stock definition.
That's my first guess anyway.
How much deeper is your pocket than the model? The code should output to the geometry if you selected the contour (or face) at the bottom, but if your stock is defined as .04" oversize (the default) then if you touch off the top of stock that is meant to be Z0, you'll get deeper features by virtue of the stock definition.
That's my first guess anyway.
Neal Stein
New to Fusion 360 CAM? Click here for an introduction to 2D Milling, here for 2D Turning.
Find me on:
Instagram and YouTube
New to Fusion 360 CAM? Click here for an introduction to 2D Milling, here for 2D Turning.
Find me on:
Instagram and YouTube
Fusion