12-06-2021
08:43 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
12-06-2021
08:43 AM
Hello @pseebald - wow there are a lot of people cutting signs with circular holes recently!
This is a known issue with large arcs on inside holes, we have a fix but getting it delivered to users is a slow process.
The issue is the large arc next to lines. I would say add some tiny lines along the arc to break it up into arcs less than 90 degrees.
@engineguy recently found that changing corner mode to keep sharp corners helped , see Re: Troubles with CNC plasma cuttin my fusion design so you might have success with that.

Matt Wynn
Senior Manager, Software Development, Fusion Fabrication
Fusion