Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
engineguy
in reply to: nathanhein

@nathanhein 

 

Unlikely to be a Fusion issue if the toolpath exists in Fusion and simulates correctly, without a file to check then all I can say is look at the tolerances in Fusion, may need to be a little "tighter", meaning more 0s in the setting, example going from 0.01 to say 0.0001.

 

This will also apply to your LinuxCNC settings, if the settings are too "loose" then Linux will not complete the toolpath.