Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
HughesTooling
in reply to: Anonymous


@Anonymous wrote:

 

BUT, when I turn the 1/2" off and have the two 1/4" pieces shown and start the second setup, it still wants to only grab where the 1/2" piece was. It doesn't readjust to what I have on the screen. I hope this makes sense....

 

 

 


 

I think you're describing the bug where setups created after the first default to From Preceding. @seth.madore Any idea when this is getting fixed? This should be quite a high priority as it is something you run into several times a day, probably a few hundred times since in was introduced!:persevering_face:

HughesTooling_0-1636796349162.png

@Anonymous you just need to select one of the other options.

HughesTooling_1-1636796567893.png

 

Mark

 

Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

EESignature