10-28-2021
02:32 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
10-28-2021
02:32 PM
I adjusted the setup for each toolpath. I am sure not ideal but I ain't no Fusion pro. I don't know how to model the letters other than flat bottom. I knew the V-bit would create a V groove and that was my intent. I'm still learnin. I think the engrave looks good. Here is a better pic. And a pic showing tabs, they came out great! I should also point out that this is a scaled down version of my final product. Testing to make sure I can get the right toolpaths and ultimately, the right outcome. Open to suggestion as I learn and I appreciate your insights and feedback.
Fusion