Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
berndoechsler
363 Views, 7 Replies

Turning_CAM Setup - left hand tool on a inclined bed lathe

Hello everyone!

 

I am new in turning CAM but already familiar with Fusions milling CAM.

Some days ago I bought a small nice inclined bed lathe with RÖHM hydraulic chuck SAUTER tool turret and Sinumeric 802s control. I am trying to get the setup done but always kind of fail. I tried several scenarios and as below in the pictures this are the ones closest to the right setup. But still as you can see either the tool is switched down and starts from the right side or is positioned right but starts from the wrong side. I tried everything but could not find a solution.

A setup with standard inclined bed lathe should not be ss. revolutionary or am I wrong?

 

I welcome any help20211004_185218.jpgBsp.1.JPGBsp.2.JPG!!

 

Thanks!

 

Bernd