04-22-2016
11:03 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
04-22-2016
11:03 AM
Mark,
Thank you. I wish I understood better how it uses all the settings. What I had DID work, on that same part, in a different file.
I'll try what you suggested, and report back.
Yes, I'm aware the model is a little buggered - I'll look into that. The assembly was created in Soldiworks, exportes as a STEP, and imported into Fusion - a VERY inconvenient way to work, but too much work to move the whole design into Fusion right now.
Regards,
Ray L.
Fusion