Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.
HughesTooling
in reply to: Anonymous


@Anonymous wrote:

Model is checked, Model Surfaces selected, and the face I want machined is highlighted.

 

Regards,

Ray L.

 


 

It will be easier if you upload a file. The bit above sound wrong, you should only use boundaries to contain the toolpath the model selection in an op is only used if you want to add patches to the setup model to corver holes and pockets.

Clipboard02.png

 

Mark

 

 

Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

EESignature